Kyocera Printer Error Codes and Solutions
Share
| Error Code | Error Message | Possible Cause | Solution |
| C3100 | Error occurred in the main charger unit | The main charger unit is faulty or dirty | Clean the main charger unit. If the error persists, replace the main charger unit |
| C6000 | Fuser unit error | The fuser unit is faulty or has reached its end of life | Check if the fuser unit is installed correctly. Replace the fuser unit if necessary |
| C6050 | Abnormally low fuser unit thermistor temperature | The fuser unit thermistor is faulty or dirty | Clean the thermistor. If the error persists, replace the fuser unit |
| C6400 | Zero-crossing signal problem | There is a problem with the power source | Check the power source and voltage. If necessary, replace the power supply |
| C8000 | Engine communication error | There is a communication error between the engine board and the system | Check the engine board and system connections. If necessary, replace the engine board |
| C8100 | EEPROM error | The EEPROM data is corrupted | Replace the main board |
| C8800 | Engine power source error | There is a problem with the engine power source | Check the engine power source. If necessary, replace the power supply |
| C9100 | Broken fuser heater wire | The fuser heater wire is broken | Replace the fuser unit |
| 7410 | Drum unit non-installing error | The drum unit is not installed properly | Install the drum unit correctly |
| 6000 | Broken fuser heater wire | The fuser heater wire is broken | Replace the fuser unit |